|
This is the new Xecuter LT Switch v1.5 - the latest version in the best
selling Xecuter LT Switch range.
Now Includes MULTI-R Function. It was discovered that a small number of Liteon
drives would not dump the firmware with a 20 ohm resistor - but required an 18
Ohm or 22 Ohm resistor - so now you can select between 18, 20 and 22 Ohms !
(Default should be set to 20 Ohms - this will work 99% of the time)
The installation is very simple and takes about 5 minutes if you have some small
experience with a soldering iron. It has been tested with the latest Jungle
Flasher 0.1.73. All Liteon drive versions have been tested with 100% Success
(Including the troublesome Winbond IC). There is no need to remove the LT Switch
after it has been installed - simply switch to normal mode and you are good to
go. Even if you have to upgrade in the future - you don't have to touch the
switch again !
Features:
* The Only Liteon Solution Recommended By Team Jungle !
* Enables Read/Write on ALL Liteon 74850, 83850, 93450 DVD Drives
* Easy & Simple Install - Install Once & Forget
* Enable / Disable Switch
* Multi-R Switch (18, 20, 22 Ohms)
* Supports both Winbond & MXIC Chipset
* On/Off LED
* No Need To Uninstall
* Works with ALL tools | 
